Home :: OSD / Telemetry :: DJI Innovations :: Phantom2 Video & Power Cable for iOSD Mini (ImmersionRC ~ FatShark vTx)
Close
Details to FREE USA Shipping. We specialize in FPV Drone parts. USA domestic orders over $99 can qualify for free ground shipping.
The special Free Shipping applies to orders delivered within the Continental USA, Alaska & Hawaii.
Some restrictions apply. Click HERE for more details.

Phantom2 Video & Power Cable for iOSD Mini (ImmersionRC ~ FatShark vTx)

Phantom2 Video & Power Cable for iOSD Mini (ImmersionRC ~ FatShark vTx)

With this combination video & power cable you can easily connect your DJI iOSD Mini module to a Phantom 2. It is designed to work with the Zenmuse gimbal (GoPro Hero3/3+) and ImmersionRC or Fatshark 5.8GHz FPV video transmitters (25mW to 600mW models).

Unlike other solutions this cable does NOT require soldering or disassembly of your Phantom 2. Simply strip off the plastic insulation from the Phantom2's 4-wire video cable, press the wire insertion buttons, and insert your Phantom2's four wires. Then plug your iOSD Mini and video transmitter (not included) into the cable. In case you missed it, there's no need for soldering!


The cable has a built-in LC Power Filter. The filter eliminates undesirable electrical noise caused by the Phantom's four motors. So there's no need to install any additional power filters. Plus, the cable includes a power status LED that helps diagnose problems.

IMPORTANT NOTICE: This cable is specifically designed for directly connecting the DJI iOSD Mini to an ImmersionRC (or FatShark) vTx and Zenmuse Gimbal with Hero3/3+. It's NOT compatible with ANY other hardware configurations and using it with other video transmitters may cause damage that will void your equipment warranties. Do NOT use it with the Phantom2 Vision.


There are three connectors on the cable. The white 4-pin plug mates with the DJI iOSD Mini's video port. The two black Molex plugs (2-pin and 5-pin) connect to the ImmersionRC or Fatshark 5.8GHz video transmitter. Overall length is 7-inches (19cm).

Referring to the photo below, a summary of each plug-in connector is as follows (Note: iOSD Mini and vTX are available at additional cost):

CAN-bus: Connect the IOSD Mini's CAN-bus cable to the Phantom2.

vTX: Connect the black 2-pin and 5-pin plugs to the ImmersionRC or FatShark 5.8GHz wireless video transmitter.

iOSD Mini: Connect to the white 4-pin plug to the iOSD Mini. The iOSD must be connected and correctly operating in order to have a video image. Do NOT omit this plug!

Please download the instructions for complete installation details.

 

Installation Instructions: Click Me!
Details
SKU #CABP2-IRC-IOSD
Ship Wt. 0.07 lbs
 
Our price: $22.95 Item In Stock!
Options
Quantity
Wire insertion buttons.
Power LED
Cable / Plug Locations

Payment Logos Bitcoins accepted here