This step-down Voltage Regulator accepts 14.8V - 23.0 VDC (4S - 5S LiPO) on its input and outputs 12VDC at up to 2.5A continuous. Its DC-DC technology allows it to operate cooler than traditional linear regulators. However, some installations may require forced airflow for safe operation.
The DC input has 2-inch bare leads (Red wire = BAT+). The 4-inch long output cable has a 3-pin servo style connector, wired as follows:
Red: +12VDC Output
Black: Ground
Note: Do NOT directly plug the regulator's servo plug into a R/C system! Its 12V power is too high and will damage your R/C components.
Specifications:
Input: 14.8 - 23.0 VDC
Output: 12VDC, up to 2.5A continuous (3.0A peak <10 Sec)
Technology: Switch-Mode Regulator
Load Regulation: 5% typical
Switching Freq: 300KHz
Ripple: 90mV @ 1.5A typical
Size: 2.0 x 1.0 x 0.5 inch (51x26x13mm)
Weight: 13 grams
Origin: Made in China by AEO Tech
|