This Voltage Regulator has an adjustable 1.2VDC to 30VDC output. Due to its unique design, the output voltage can be set higher or lower than the input's voltage source. It uses DC-DC switching technology so it operates substantially cooler than common linear regulators.
The circuit board has four pads (soldering required) that are labeled as follows:
IN+ : Battery/Power In +
IN- : Battery Ground
OUT+: Regulated Voltage
OUT-: Common Ground
Specifications:
Input: 3-35VDC
Output: 1.2VDC-30VDC 2A / 10W maximum
Switching Frequency: 60KHz typical
Output Ripple: 150mV at 10W loads typical
Technology: Switch-Mode SEPIC Regulator
Voltage Adjust: Screwdriver Access
Size: 1.9 x 0.9 x 0.5 inch (49x22x12mm)
Weight: 15 grams
Our PSF-001 LC filter (available separately) is a popular accessory choice for this regulator.
|